Rubber sheathed cable
- Tel:+86-0550-7516689
- Fax:0550-7513058
- Mail:ahhl@ahhonglin.com
Description
1、 Equipment: small pressure equipment with automatic temperature control, timing and multi specification tubular cavity.
2、 Rubber: it is consistent with the wire of the repaired wire, and the rubber content is higher than that of the repaired material, and the vulcanization system is slightly stronger.
3、 Operation method:
1. Set the temperature and time according to the vulcanization system of the compound;
2. Wipe and wash the repair place with rubber and ink diluent, especially the joint shall be fully treated;
3. Cut the repair rubber properly according to the size of the gap, and pay attention not to be too much or too little;
4. Plug the cut rubber in the gap, and pay attention that the rubber shall not be higher than the circumference of the wire;
5. Wrap it with high temperature resistant PP tape. And put it into the tubular die cavity slightly smaller than the wire diameter, lock the upper and lower dies, and make the supplemented position have a certain pressure. Note that the die cavity diameter is slightly smaller than the wire diameter by 0.1 ~ 0.2mm;
6. When the vulcanization time is up, take out the product. If a small amount of rubber overflows, repair it with a sharp blade and wipe it with diluent.
4、 Verification method:
Press an appropriate amount of air into the repaired wire and place it in water. It can be judged whether there is air leakage.
